Timbakote Timber Pro Rustic Coating System

Timbakote Timber Pro Rustic

Timbakote Timber Pro Rustic is a tough acrylic water based coatings system designed for New Zealand's harsh conditions. The Timber Pro Rustic coating system gives excellent adhesion to timber, fibre cement and concrete substrates. Timber Pro Rustic is eco-freindly and approved by Environmental Choice New Zealand. Available in a wide range of popular colours.
 
Recommended Uses
Application
Application
Coverage
Drying Times
Clean Up
Safety
Disposal
 
 
Download the pdf pdf-logo-W-SMALL.jpg(396kb) of the product information
 

RECOMMENDED USES

Timbakote Rustic Coating system is an ideal finish for all exterior bandsawn timber, textured fibre cement weatherboards and rough cast concrete.
 

SURFACE PREPARATION

New Timber should be clean and dry, free of any loose fibres. Sharp edges must be sanded, nail holes and minor defects to be filled with suitable quality timber filler.
Exposed Timber (greater then one week), remove any contamination; loose timber fibres and treat with sugar soap solution Complete as per new timber.
Previously oiled or stained timber: remove all poorly adhering coatings, sand and treat with a sugar soap solution . Complete as per new timber.
Fibre Cement Weatherboards and Concrete Should be clean and surfaces dry, free from contaminants.
 

APPLICATION

Stir all coatings well before and during use with a flat stirrer.

Apply 1 coat of Timbakote Rustic Basecoat with a good quality paintbrush, applicator pad, roller or spray.
Allow up to 2 hours for Timbakote Rustic Basecoat to dry. 

Apply 2-3 coats of Timbakote Timber Pro topcoat to achieve the desired timber colour. Do not over spread, as achieving the correct film build is important to the life of semi-transparent coatings.

Thinning is not generally recommended, as it can be detrimental to the coatings performance. The addition of 50mils of water per litre may be required in hot weather or when coating absorbent surfaces.
 

COVERAGE

Timber Band Sawn    4 - 10 sqm per litre
Timber Dressed    7 - 12 sqm per litre
Fibre Cement Weatherboards  7 - 12 sqm per litre
 

DRYING TIMES

Depending on such factors as film thickness, ambient air temperatures, humidity levels and air circulation. The general dry times at 6-12 sq metres per Litre are: Touch dry 20 minutes - Recoat time 2 hrs - Curing time 7 days.
 

CLEAN UP

All equipment can be cleaned up in water.
 

SAFETY

Wear impervious gloves and wash paint deposits off skin with soap and water.
Moderately irritating to eyes- wear splash proof goggles to protect eyes. Flush eyes immediately with plenty of water if coating splashes to the eyes occur. If discomfort persists seek medical attention. Keep out of children's reach. Ingestion; Give 1-3 cups of water and seek medical attention.
 

DISPOSAL

Let residual coating dry by leaving the lid off the container. Dispose with refuse if permitted by local council. Paint containers are reusable for non-food purposes and recyclable in areas where recycling and collection facilities are available

Every care is taken to ensure that the information provided in this data sheet is accurate. Timbakote Ltd is unable to guarantee results as it has no control over the conditions under which products are applied, the substrate or the application. The customer has to determine the suitability of the delivered products or information for its intended purpose.
About our company
Enter a succinct description of your company here
Contact Us
Enter your company contact details here